Using this valve is easy. Follow these steps.
1. Turn off the main supply. Do this before you fit the valve.
2. Fit the valve to the pipe. Screw it on tight. Use thread tape for a firm seal.
3. Point the handle the right way. Make sure it can turn a full quarter turn.
4. Open it slowly. Turn the handle until it runs along the pipe.
5. Check for drips. If you see any, tighten the
joints a little.
6. Shut it when needed. Turn the handle across the pipe to stop the flow.
Next, turn the handle once or twice a year. This keeps it smooth and ready for use.
Quick tip: Use the valve fully open or fully shut.
Do not leave it half open for a long time. It can wear down the parts inside.